BUsiness

Find out how to Build a Shelf Utilizing Brackets

Brackets are available in a myriad of shapes and sizes. Utilizing brackets to support and create a shelf permits the shelf to be coordinated with the room decor, be customized-sized, and be built by an intermediately expert home decor DIY-er. A number of shelves, staggered on a wall, make a critical design statement. A shelf placed above a door is a found-house storage resolution, and a series of cabinets running round a room’s perimeter, high on a wall, could make a lateral book case for a small library.

Step 1

Choose brackets that may accommodate the chosen shelf. A typical shelf is 12 inches deep. This is the measurement from the entrance of the shelf to the wall. Brackets are basically “L” -formed; one leg of the L is attached to the wall, the opposite leg, which protrudes from the wall at a ninety-degree angle, supports the shelf. The length of the protruding leg must be a minimum of -thirds of the depth of the shelf. For example, if the desired shelf is 12 inches deep, the supporting legs of the bracket should be at least 8 inches. Usually, each legs of the brackets are the identical length; but this will not be a hard rule.

Step 2

Choose the number of brackets to use for the shelf. If the brackets are spaced too far apart, the shelf will sag. A very good rule of thumb is to put a bracket every sixteen inches. Place one at every end of the shelf, 1 inch from the outside edge, and every sixteen inches along the shelf length.

Step 3

Mark the wall, with the self-erasing marker, at the position of the underside of the shelf. Measure the distance from the floor to this mark. The 90-degree angle of the bracket will likely be aligned with this mark. The shelf will sit on the legs of the brackets that protrude from the wall at this mark. Mark the wall, measuring up from the ground, at sixteen-inch increments, one location marker for each bracket and one mark for each of the tip brackets.

Step four

Install the brackets onto the wall at the indicated bracket locations, following the producer’s directions for attaching the brackets to the wall.

Step 5

Place the shelf, centered, on top of the brackets and insert screws up via the brackets into the bottom of the shelf to secure it into position. It is useful to pre-drill the screw holes to forestall a wood shelf from splitting.

If you’re ready to learn more information on Hook Shelf Bracket have a look at the web site.