BUsiness

Learn how to Install Countertop Brackets

Countertop brackets are a good way to boost the looks of your kitchen. Brackets that poke out of the wall are usually bland and unattractive, however countertop brackets can easily be very elaborate, virtually resembling real cast iron brackets in their ornamentation. Installing countertop brackets might be one of the easiest house improvements you can do, and if you have even essentially the most fundamental of expertise, you may set up these things in a few hours or less. Some individuals advocate that you’ve your countertop brackets installed by a professional, however so long as you might be careful, and take the time to measure accurately, there isn’t a reason why you shouldn’t be able to put in them yourself. Just observe a few easy guidelines to finishing this project, and you need to have it achieved with none effort at all.

Step 1 – Preparation

Earlier than you being to make any holes for your countertop brackets, you will have to mark on the wall where you need them to go. There are two things that you will have to take notice of. The first is the wall stud. You’ll be able to locate this either by tapping along the wall until there is a change between hollow and otherwise, or you may use a stud finder, which is an electronic machine which will locate the studs for you. In addition, you need to ensure that you can be installing the countertop brackets on a straight line. The easiest way to do this is to mark where you want the primary bracket to be, and then use a spirit stage to work out the place the correct angle is. Mark in pencil on the wall the place the holes should go.

Step 2 – Drill a Hole

The primary gap will need to be drilled straight into the wall stud. Only go a certain size into the wall, perhaps an inch or so utilizing a really fine drill bit. The reason for this is that you’ll want to install plastic anchors which will hold the screws on the wall, and never permit them to slip down, and you might want to drill a gap which is slightly smaller than this anchor, so the wall holds it tightly.

Step 3 – Becoming the Anchor

Upon getting drilled the hole, screw or hammer your anchor into position. The anchor will be the system which is holding your bracket onto the wall, and in flip holding the countertop to the wall, so you possibly can see that it needs to be a tight fit. You should purchase a range of plastic anchors in several sizes, so make sure that you have chosen the one which will greatest hold your screw in place.

Step four – Fitting the Bracket

Now take the bracket, and place the screw hole over the anchor. Add a screw, and drive it into the anchor with your screwdriver. Do not tighten it up but, but insert the entire brackets into the wall, after which go around screwing them all in tightly. Check that they’re straight, and then place your countertop over them.